On Sat, 2009-10-17 at 07:30 -0400, gene glick wrote: > > Alternatively, if you don't want the 3D stuff, just the GL rendering, > > the "before_pours" branch should be good. > > > > git clone git://repo.or.cz/geda-pcb/pcjc2.git > > cd pcjc2 > > git checkout -b before_pours origin/before_pours > > autogen.sh > > ./configure --enable-dbus --enable-gl > > make > > make install > > > > > > This build has the 3d stuff too - unless I did it wrong :)
Hmm, yes.. technically.. although it doesn't draw any z-coordinates, so if you adjust the trackball - you will always see the same flat board (at an angle). _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
