Peter Clifton wrote: > On Sat, 2009-10-17 at 07:09 -0400, gene glick wrote: >> Peter Clifton wrote: >> >>> The checkout commands would be: >>> >>> git clone git://repo.or.cz/geda-pcb/pcjc2.git >>> cd pcjc2 >>> git checkout -b local_customisation_no_pours >>> origin/local_customisation_no_pours >>> autogen.sh >>> ./configure --enable-dbus --enable-gl >>> make >>> make install >>> >>> >> 1st try, works fine. Any command to return to normal view? I can't >> seem to get it back after futsing with it :) > > No - getting it back is near impossible ;). I will add a button when I > get a moment! >
Hi Peter, Well, this version of PCB has again crashed my Linux system. I really like to use it to run the ":ExecuteFile(myPCB.cmd)", for example because it's so fast. Then I added about 5 parts, placed 1, then was going to route 2 new parts. Bam. Linux crashed. It takes a pretty long time for fsck to repair everything and get back to normal. Any thoughts to why this keeps occurring? Any chance it's that d-bus stuff you are using? My setup: gateway laptop Dual Pentium Slackware kernel version 2.6.27.7 desktop is KDE 3.5 regards, gene _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
