On Feb 3, 2010, at 7:51 PM, Dave N6NZ wrote: > I've got a pcb where close tracks through polygons are leaving thin shards of > copper between tracks. These are 8 mil tracks on a 10 mil grid. Seems to me > these have always been cleared out in the past because they are below minimum > copper size, but then again, I usually close space my tracks -- this is a > very sparse, somewhat silly design my daughter is doing, so no design rules > are being pushed. (But hey, if you can get a 10 year old kid begging to > design pcb's, it seems like a worthwhile use of time and money...) > > Anyway, am I misremembering, missing a setting someplace, or is this a glitch > in this particular build? Hmmmmm.... guess it was just me. I have discovered the 'k' key -- I guess in the past when I've used 8/8 rules I've always jammed my tracks at minimum spacing in polygons and simply never noticed this behavior before.
-dave _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
