> I believe there are some fab's who run a DRC check with a web interface > as you upload the design files. I doubt this will be available until > you've committed to fabrication though.
freedfm from 4pcb is free but it sucks and they will spam you. anyway, if you're at the point where you need to rely on web-based DRC for gerbers (thus you don't trust the tools you use) its time to move on > > -- > Peter Clifton > > Electrical Engineering Division, > Engineering Department, > University of Cambridge, > 9, JJ Thomson Avenue, > Cambridge > CB3 0FA > > Tel: +44 (0)7729 980173 - (No signal in the lab!) > Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me) > > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
