Peter Clifton wrote:
On Sat, 2010-04-24 at 06:04 -0400, Jim wrote:
If I take my project.rc file and copy it to project.gsch2pcb and
change
the output-name to something else so I don't clobber my ongoing
development and run xgsch2pcb, pcb then gives me a bunch of errors
Did you copy your board as well, or are you starting from a blank one?
Starting from a schematic only. I let it build the board, netlist, etc.
Try hitting "O" after opening the board you run gsch2pcb manually on..
does it have any messages then?
Log:
Can't add rat lines because no netlist is loaded.
Can't add rat lines because no netlist is loaded.
Importing PCB netlist /home/jwl/gaf/ether/etherboard.net
65 rat lines remaining
The first two lines were generated because I had not loaded the netlist
yet. O apparently wants a netlist to build rats from :)
Thanks,
Jim.
_______________________________________________
geda-user mailing list
[email protected]
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
