On Sat, 2010-04-24 at 09:19 -0400, Jim wrote: > Peter Clifton wrote: > > On Sat, 2010-04-24 at 06:04 -0400, Jim wrote: > > > >> If I take my project.rc file and copy it to project.gsch2pcb and > >> change > >> the output-name to something else so I don't clobber my ongoing > >> development and run xgsch2pcb, pcb then gives me a bunch of errors > >> > > > > Did you copy your board as well, or are you starting from a blank one? > > > Starting from a schematic only. I let it build the board, netlist, etc. > > Try hitting "O" after opening the board you run gsch2pcb manually on.. > > does it have any messages then? > > > Log: > Can't add rat lines because no netlist is loaded. > Can't add rat lines because no netlist is loaded. > Importing PCB netlist /home/jwl/gaf/ether/etherboard.net > 65 rat lines remaining > > The first two lines were generated because I had not loaded the netlist > yet. O apparently wants a netlist to build rats from :)
Probably, if you load the net-list, and hit "O", it will complain the same as with xgsch2pcb until you've separated all your parts out so they don't touch. Best wishes, -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
