> This is a DRC issue. The rules should allow any net to connect > to no-net copper. No need to restructure the way pcb handles > connectivity.
If different nets connect to the same no-net copper there is a short between nets. Consider a large item like you might solder a RFI shield to, that covers the perimeter of a large board. It would be easy to not notice different nets connected at different times, at opposite ends of the board. So I'd constrain your idea to a single net. Even then it would be better to have a warning that could be turned off per net. Maybe that connection was not intentional? _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
