Actually, to get the GND net to tie in with the VSS net do I have to go down into each symbol in gschem and replace net=VSS:8 with net=GND:8? Same with Vcc and VDD?
On Mon, May 2, 2011 at 2:21 PM, DJ Delorie <[1][email protected]> wrote: > 1. How do I set up the groups and layers in preferences for 3 > signal planes and the one groub? In PCB there's no real difference between a signal plane and a power/gnd plane. Just set up any 4-layer board. > 2. Once I create the rectangle of the ground plane, how do I get > PCB to attach the GND and the VSS nets to that ground plane when I > auto-route? I've never had much luck getting the autorouter to do this. I usually pre-route all the power/gnd connections because I want them to have short fat traces, then let the autorouter do the signals. _______________________________________________ geda-user mailing list [2][email protected] [3]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user References 1. mailto:[email protected] 2. mailto:[email protected] 3. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
