On Fri, 20 Jun 2003 21:51:53 -0400 Ales Hvezda <[EMAIL PROTECTED]> wrote:
> > [ Ales here, I'm reposting this since majordomo didn't recognize the > e-mail as being subscribed to the geda-dev/user mailinglist. Please note > that I am not the original author. ] > > -- Cut here -- > From: Ed Richley <[EMAIL PROTECTED]> > > Hi: > > So, I've been trying to use gschem and pcb to make a board with > both SMD and through-hole parts. Most of it is going well, but > I ran into a problem. There's probably a simple answer, but I can't > find it anywhere. > > My pcb version is 1.6.3 (the latest sable version, according to the > pcb page). > > The problem is that I want to put SMD components on the solder side > of the board as well as the component side. Since there are no SMD parts > (I didn't find any resistors or caps) in the library, I made a few > using the instructions. It all seems to work OK, but the parts only > come out on the component side. I need to put some parts on the > solder side, and I can't figure out how to get them there. > > Can someone give me an idea of how to copy a SMD to the opposite side? > > Thanks. > > > Ed Richley > > >From memory (and I havent got a working pcb atm, as ive just installed Gentoo Linux) >the "j" key will swap the part to the solder side. -- Kind Regards Terry Homemade pcbs using Gnu/LinuX gEDA/PCB page :- http://w3w.arafuraconnect.com.au/~tp/pcbs.html Gnu/Linux/Debian-3.0 Registration Number: 103931 :http//counter.li.org * Free Software provided by GNU; http://www.gnu.org/philosophy/free-software-for-freedom.html
