On Sunday 20 February 2005 12:58, Peter Kaiser wrote: > > It still lacks the plot of the voltage across nodes 1 and 2 (VAC), which > > is one of the ones I want to show. It has VAC#branch, but that has a > > magnitude of approx 2V, not the 200V that it should be. > > VAC#branch is the current through VAC. Would a current of 2A be the right > value?
There's a 10ohm resistor as load, I = V/R = 200/10 == 20A?(assuming DC) I'm not sure how the diode bridge affects this, but 2A seems a little bit low to me. In interactive mode I plotted I(1) and I(2), and they varied between 0 and 200, which is sortof what I would expect, seeing as the output is not really DC. > May be the value V(1,2) is not covered by the command ".save all". > Could you try ".save V(1,2) or may be the "define" command together > with .control. .save V(1,2) just saves V(1) and V(2) into the raw plot. I don't know how to use those define and .control things. ngspice still segfaults when I run it in batch mode, without raw output. I don't want to use interactive mode, because I want to specify what I want to see in my input file. Steven
