On 2/19/06, DJ Delorie <[EMAIL PROTECTED]> wrote: > > > * make the pins 100 units long. > > Isn't the standard 300 mils (3 grid steps) long?
The standard is 300 mils. My preference is to make smaller symbols. > How do you place pin numbers when there's an inversion bubble? I usually do not use the inversion bubble (but I probably should). I looked at your symbol and it is very similar to symbols that I create. > > * group related pins 200 units apart. A minimum space of 300 units between > > pin groups. > > Spec says 400 units for related pins. I used 800 units (i.e. skip a > pin) to separate groups. My preference is for smaller symbols. > > * I usually place the refdes in the upper left corner and the mfg > > part number in the lower left corner. > > What about other notes, like generic part type (i.e. RAM size)? I > chose centered in the box so I could list as many as needed. If there are a lot of notes or long part numbers I would center the part number and notes like you did. (* jcl *) -- http://www.luciani.org
