Did you make sure you have all system files at dist/m5/system folder and M5_PATH environment variable set properly?
As Nilay suggested, if you look at simout and simerr files, you will very likely see that it is looking for disk image file, swap file, and kernel. Cagdas On Jan 16, 2015, at 11:59 AM, Nilay Vaish via gem5-dev <[email protected]<mailto:[email protected]>> wrote: On Fri, 16 Jan 2015, mike upton via gem5-dev wrote: I was trying to run a regression, I am still learning. This is off of a clean build of the top of tree: hg clone http://repo.gem5.org/gem5 I ran: util/regress -j4 --builds X86 and I get a number of failures. ***** build/X86/tests/opt/quick/se/00.hello/x86/linux/o3-timing passed ***** build/X86/tests/opt/quick/se/00.hello/x86/linux/simple-atomic passed ***** build/X86/tests/opt/quick/se/00.hello/x86/linux/simple-timing passed ***** build/X86/tests/opt/quick/se/00.hello/x86/linux/simple-timing-ruby passed ***** build/X86/tests/opt/quick/fs/10.linux-boot/x86/linux/pc-simple-atomic FAILED! ***** build/X86/tests/opt/quick/fs/10.linux-boot/x86/linux/pc-simple-timing FAILED! The failures are both of the fs tests. Am I doing something wrong? Typically I look at the files simout and simerr in the directory for the test to get an idea about what went wrong. -- Nilay _______________________________________________ gem5-dev mailing list [email protected]<mailto:[email protected]> http://m5sim.org/mailman/listinfo/gem5-dev _______________________________________________ gem5-dev mailing list [email protected] http://m5sim.org/mailman/listinfo/gem5-dev
