Hi Tushar, Thanks for your reply. Can you please tell me if router[0] which is connected to DMA_controller(is this same as memory controller?), has any different structure or functionality than other routers? If yes, could you please let me know which file has the code for this? If no, could you please let me know if we can implement a different functionality for just one router? Also, regarding routing destinations, can you please tell me where does the routing_table_entry variable in routing_unit.cc gets its value from? I am unable to figure these things out by looking at the code and hence stuck at one point. Hope to hear from you soon.
On Thu, Oct 27, 2011 at 9:11 PM, Tushar Krishna <[email protected]>wrote: > Hi Tejasi, > > In general there is *no fixed rule* for these, and depends on the > coherence protocol. > For most protocols currently in gem5, each "Directory" Controller implies > both a Directory (i.e. state) and a Memory Controller. > The memory controller models the delay to main memory. We don't define and > connect a memory module separately as far as I know. > The number of directories is an independent parameter defined from command > line (--num-dirs). > > If you take a look at configs/ruby/MOESI_CMP_directory.py, > you can see that it creates L1 controllers, L2 controllers and Directory > Controllers (in which it creates both a DirectoryMemory => state, and a > memory controller). > Now when the directory receives a request that is not currently on-chip > (indicated by directory state), it sends the request to the memory > controller which models memory delay for reads/writes etc ... [done in the > protocol's .sm file]. > > In terms of connections, all controllers (L1, L2 and Directory) can be > connected in any manner. > We provide two mesh topologies: Mesh.py and MeshDirCorners.py. > Both topologies create a Mesh with the number of routers = number of cpus > (=number of L1s). > Mesh.py assumes equal number of all controllers (L1, L2 and directory), > and connects one L1, one L2 (if it exists) and one directory to each > network router. > MeshDirCorners.py assumes 4 directories and connects them at each corner. > All DMA controllers are just connected to router 0 (arbitrary decision) I > think. > > You can design your own topology too using the given ones as reference. > You just need to add a .py file of your topology in the topologies folder, > and also add it in > src/mem/ruby/network/topologies/SConscript > > Hope this helps, > Tushar > > > > On 10/27/2011 4:09 PM, tejasi pimpalkhute wrote: > > Hi, > > I was looking into the code file Mesh.py in Topology folder and the > online documentation for it says that every node has L1,L2 cache and > directories connected to it. As I had read somewhere, in Gem5, directory > controller and memory controller are same, could you please let me know if > Directory connected to each node is same as main memory? Also, it seems > that DMA controller is attached to only remainder nodes as per the code. > So, it is a little bit confusing. Could you please elaborate the > connections of nodes to memory controller and main memory. > > Thanks! > > > > > > _______________________________________________ > gem5-users mailing > [email protected]http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users > > > _______________________________________________ > gem5-users mailing list > [email protected] > http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users > -- Thanks and Regards, Tejasi
_______________________________________________ gem5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/gem5-users
