Hi folk. I see that my small problem has been interesting. Thanks for your help.
> > Rate 6 is 20 Gb/sec whereas 3 is 10 Gb/sec. So the port is 4x DDR (rate > > 6) and the group is 4x SDR. The request is for equal to the rate so it > > fails. > > > > Are all your ports DDR or do you have a mix ? If all are DDR, you can > > configure the default partition to use this rate. > > To elaborate a little more on this, the configuration would be done via > /etc/osm-partitions.conf file with a single line as follows: > > Default=0x7fff,ipoib,rate=6:ALL=full; > I have identical DDR HCA and DDR switch. I configured the default partition with the same rate. The problem has been solved. > > > > > > If modules was builded with --without-ipoib-cm then ib_ipoib don't depend > > > on ipv6. > > > But the messages remain the same in log. > > Are you using IPoIB (for IPv4) ? If so, is that working ? > > -- Hal Yes I use IPoIB and I think that is working. At least the tests, benchmarks and our parallel tasks is working. Thanx. _______________________________________________ general mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
