Hi,
On Wed, 23 Apr 2008, Roland Dreier wrote:
Hmm, not sure... let's see what the Mellanox guys say (they're mostly on
vacation this week so it might be a few days).
The only things I can think of to try are:
- go to mellanox.com and get latest FW and make sure there's not
anything strange about what's on your card (but given that it is seen
by the driver, the FW must at least have a valid checksum I think)
I can't locate the correct firmware, the PSID reported by mtsflint
corresponds to an Intel one:
Image type: Failsafe
I.S. Version: 1
Chip Revision: A0
Description: Node Port1 Sys image
GUIDs: 0002c9020022baa4 0002c9020022baa5 0002c9020022baa7
Board ID: (INT0010000001)
VSD:
PSID: INT0010000001
But I haven't been able to find any firmware in Intel's webpage.
Do you think that I could use a Mellanox firmware? Which one? There
are three different ones for the MT25204.
- if you're building your own kernel, try the Debian 2.6.24 generic
amd64 image and see if that's any different, because I definitely
have mt25204 HCAs working with that.
I tried with 2.6.18 (the default etch kernel) and it gave the same
problem.
Finally, I upgraded the BIOS of the machine (to version 85 from 79) and
the module is loaded without problems and everything works correctly. So
probably it was motherboard issue.
Regards,
Xavier
_______________________________________________
general mailing list
[email protected]
http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general
To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
