On Fri, Mar 27, 2009 at 6:20 PM, Yicheng Jia <[email protected]> wrote: > >> That's max'd out so should be cleared to see if it is continually >> incrementing. > > The number doesn't change after the subnet is up.
It's an 16 bit counter which is max'd out and IBTA counters are sticky so once it gets to 65535 it stops unless it's cleared. Did you clear it ? >>Get the portinfo on the SM peer port. Something like: > >>smpquery -D portinfo 0,1 > >>assuming you are doing this from the SM node. > > What if I am running it on a node other than SM node? I don't have tools to > run on SM node now. Are you familiar with directed routes ? If not, you should read that part of the IBA spec (vol 1 14.2.2). >> So different cables are in use ? Same HCA for OpenSM though ? > > The cables are all the same type. HCAs are all same as well. I'm asking whether in the different occurences of this issue (with Cisco and QLogic switches), the same cable and HCA were used for the OpenSM node or whether these are totally separate configurations. -- Hal > Thanks! > > Yicheng Jia _______________________________________________ general mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general
