Please use "-F" option while running the tests. It will ignore the "Conflicting CPU frequency" errors. You will still see these messages on your screen, but with "-F", you will also see the results.
Regards Karun -----Original Message----- From: general-boun...@lists.openfabrics.org [mailto:general-boun...@lists.openfabrics.org] On Behalf Of Sneha Mistry Sent: Tuesday, September 22, 2009 2:35 PM To: general@lists.openfabrics.org Subject: [ofa-general] Problem while running ib tests Hi, I have two Dual port HCAa card.Which I have installed in same PC. I am using OpenSuse 10.3 and installed OFED 1.4. If I try to run any IB bandwidth test or latency test it end us with warning "Conflicting CPU frequency values detected: 2394.000000 != 1596.000000". Is it an OFED related problem or Linux kernel problem. HCA are connected back to back and output of ibstat is as given below. --------------------------------------------------------------------------------------------------------- CA 'mthca0' CA type: MT25208 (MT23108 compat mode) Number of ports: 2 Firmware version: 4.8.200 Hardware version: 20 Node GUID: 0x0002c90200283734 System image GUID: 0x0002c90200283737 Port 1: State: Active Physical state: LinkUp Rate: 20 Base lid: 1 LMC: 0 SM lid: 1 Capability mask: 0x02510a6a Port GUID: 0x0002c90200283735 Port 2: State: Initializing Physical state: LinkUp Rate: 20 Base lid: 0 LMC: 0 SM lid: 0 Capability mask: 0x02510a68 Port GUID: 0x0002c90200283736 CA 'mthca1' CA type: MT25208 (MT23108 compat mode) Number of ports: 2 Firmware version: 4.8.200 Hardware version: 20 Node GUID: 0x0002c90200283730 System image GUID: 0x0002c90200283733 Port 1: State: Initializing Physical state: LinkUp Rate: 20 Base lid: 0 LMC: 0 SM lid: 0 Capability mask: 0x02510a68 Port GUID: 0x0002c90200283731 Port 2: State: Active Physical state: LinkUp Rate: 20 Base lid: 3 LMC: 0 SM lid: 1 Capability mask: 0x02510a68 Port GUID: 0x0002c90200283732 -------------------------------------------------------------------------------------------------------------------------------------- Even ibibnetdiscover is detecting one hope. So there is nothing wrong if I try to test 2 HCA connected back to back. Please tell me what can be done for running ib tests. Thanks, SGM _______________________________________________ general mailing list general@lists.openfabrics.org http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general _______________________________________________ general mailing list general@lists.openfabrics.org http://lists.openfabrics.org/cgi-bin/mailman/listinfo/general To unsubscribe, please visit http://openib.org/mailman/listinfo/openib-general