I have just installed gentoo on my ibook 12". It has dual boot with
yaboot. Sometimes it works fine but sometimes, without any reason it
starts as follows and stops:
> NET: Registered protocol family 16
> PCI: Probing PCI hardware
> PCI: Cannot allocate resource region 0 of device 0001:10:18.0
> PCI: Cannot allocate resource region 0 of device 0001:10:19.0
> SCSI subsystem initialized
> usbcore: registered new driver usbfs
> usbcore: registered new driver hub
> Thermal assist unit not available
> Registering PowerMac CPU frequency driver
> Low: 599 Mhz, High: 1199 Mhz, Boot: 599 Mhz
> Installing knfsd (copyright (C) 1996 [EMAIL PROTECTED]).
> NTFS driver 2.1.22 [Flags: R/W].
> inotify device minor=63
> Generic RTC Driver v1.07
> Macintosh non-volatile memory driver v1.1
> PCI: Enabling device 0000:00:10.0 (0006 -> 0007)
> radeonfb: Invalid ROM signature 0 should be 0xaa55
> radeonfb: Retrieved PLL infos from Open Firmware
> radeonfb: Reference=27.00 Mhz (RefDiv=12) Memory=190.00 Mhz, System=183.00
> Mhz
> radeonfb: PLL min 12000 max 35000
> radeonfb: Monitor 1 type LCD found
> radeonfb: EDID probed
> radeonfb: Monitor 2 type no found
> radeonfb: Power Management enabled for Mobility chipsets
> Console: switching to colour frame buffer device 128x48
> Registered "mnca" backlight controller, level: 15/15
> radeonfb: ATI Radeon \c DDR SGRAM 32 MB
> i8042.c: i8042 controller self test timeout.
> Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled
At this point it stops and nothing happens... then I need to turn the
machine off and then turn it on again. Today, in particular, I needed to
do this around 10 times before it worked ...
It doesn't seem to be hardware problem because macosx always works fine.
Maybe there is a problem with my yaboot.conf:
boot=/dev/hda2
device=/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]:
partition=5
root=/dev/hda5
timeout=30
install=/usr/lib/yaboot/yaboot
magicboot=/usr/lib/yaboot/ofboot
image=/boot/kernel-2.6.10
label=Linux
read-only
macosx=/dev/hda3
My current partition table is like that:
/dev/hda1 Apple_partittion_map
/dev/hda2 Apple_Bootstrap
/dev/hda3 Apple_HFS
/dev/hda4 swap
/dev/hda5 linux partition
Does anyone know what is the problem?
Best regards,
Flavio Leonardo Cavalcanti de Moura
email: [EMAIL PROTECTED]
homepage: flavio.mat.unb.br
--
[email protected] mailing list
