Try turning off both of these driverss: Device Drivers -> Character Devices -> Serial Drivers < > 8250/16550 and compatible serial support Device Drivers -> Input Device Support -> Hardware I/O ports < > i8042 PC Keyboard Controller
Hope this helps. --- Dræven -----Original Message----- From: Flavio Leonardo Cavalcanti de Moura [mailto:[EMAIL PROTECTED] Sent: Thursday, July 07, 2005 6:04 PM To: [email protected] Cc: Flavio Leonardo Cavalcanti de Moura (MAT-GRAD) Subject: [gentoo-ppc-user] Problem with the initialization of gentoo on ibook 12" I have just installed gentoo on my ibook 12". It has dual boot with yaboot. Sometimes it works fine but sometimes, without any reason it starts as follows and stops: > NET: Registered protocol family 16 > PCI: Probing PCI hardware > PCI: Cannot allocate resource region 0 of device 0001:10:18.0 > PCI: Cannot allocate resource region 0 of device 0001:10:19.0 > SCSI subsystem initialized > usbcore: registered new driver usbfs > usbcore: registered new driver hub > Thermal assist unit not available > Registering PowerMac CPU frequency driver > Low: 599 Mhz, High: 1199 Mhz, Boot: 599 Mhz > Installing knfsd (copyright (C) 1996 [EMAIL PROTECTED]). > NTFS driver 2.1.22 [Flags: R/W]. > inotify device minor=63 > Generic RTC Driver v1.07 > Macintosh non-volatile memory driver v1.1 > PCI: Enabling device 0000:00:10.0 (0006 -> 0007) > radeonfb: Invalid ROM signature 0 should be 0xaa55 > radeonfb: Retrieved PLL infos from Open Firmware > radeonfb: Reference=27.00 Mhz (RefDiv=12) Memory=190.00 Mhz, System=183.00 > Mhz > radeonfb: PLL min 12000 max 35000 > radeonfb: Monitor 1 type LCD found > radeonfb: EDID probed > radeonfb: Monitor 2 type no found > radeonfb: Power Management enabled for Mobility chipsets > Console: switching to colour frame buffer device 128x48 > Registered "mnca" backlight controller, level: 15/15 > radeonfb: ATI Radeon \c DDR SGRAM 32 MB > i8042.c: i8042 controller self test timeout. > Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled At this point it stops and nothing happens... then I need to turn the machine off and then turn it on again. Today, in particular, I needed to do this around 10 times before it worked ... It doesn't seem to be hardware problem because macosx always works fine. Maybe there is a problem with my yaboot.conf: boot=/dev/hda2 device=/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]: partition=5 root=/dev/hda5 timeout=30 install=/usr/lib/yaboot/yaboot magicboot=/usr/lib/yaboot/ofboot image=/boot/kernel-2.6.10 label=Linux read-only macosx=/dev/hda3 My current partition table is like that: /dev/hda1 Apple_partittion_map /dev/hda2 Apple_Bootstrap /dev/hda3 Apple_HFS /dev/hda4 swap /dev/hda5 linux partition Does anyone know what is the problem? Best regards, Flavio Leonardo Cavalcanti de Moura email: [EMAIL PROTECTED] homepage: flavio.mat.unb.br -- [email protected] mailing list -- [email protected] mailing list
