Hello,
I have this error which is rather frustrating, it is coming up on a
server that has 8 drives and two Promise controllers. I think that
the drives are not spinning up fast enough or something similar.
Pertaining dmesg output below:
PDC20269: IDE controller at PCI slot 0000:00:08.0
PCI: Found IRQ 11 for device 0000:00:08.0
PCI: Sharing IRQ 11 with 0000:00:0c.0
PCI: Sharing IRQ 11 with 0000:00:12.0
PDC20269: chipset revision 2
PDC20269: 100% native mode on irq 11
ide2: BM-DMA at 0xa000-0xa007, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xa008-0xa00f, BIOS settings: hdg:pio, hdh:pio
Probing IDE interface ide2...
hde: ST3400832A, ATA DISK drive
hdf: WDC WD2500JB-00EVA0, ATA DISK drive
ide2 at 0x9000-0x9007,0x9402 on irq 11
Probing IDE interface ide3...
hdg: WDC WD2500JB-00EVA0, ATA DISK drive
hdh: WDC WD2500JB-00EVA0, ATA DISK drive
ide3 at 0x9800-0x9807,0x9c02 on irq 11
PDC20269: IDE controller at PCI slot 0000:00:09.0
PCI: Found IRQ 10 for device 0000:00:09.0
PDC20269: chipset revision 2
PDC20269: 100% native mode on irq 10
ide4: BM-DMA at 0xb400-0xb407, BIOS settings: hdi:pio, hdj:pio
ide5: BM-DMA at 0xb408-0xb40f, BIOS settings: hdk:pio, hdl:pio
Probing IDE interface ide4...
ide4: Wait for ready failed before probe !
Probing IDE interface ide5...
VP_IDE: IDE controller at PCI slot 0000:00:11.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci0000:00:11.1
ide0: BM-DMA at 0xc800-0xc807, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xc808-0xc80f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide0...
hda: WDC WD200BB-75DEA0, ATA DISK drive
hdb: WDC WD2500JB-00GVC0, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
Probing IDE interface ide1...
Probing IDE interface ide4...
ide4: Wait for ready failed before probe !
Probing IDE interface ide5...
Thanks
--
[email protected] mailing list
