Re: [gentoo-user] Network Card not found after install

[Andrew Gaffney]

Type 'ifconfig -a' and see if eth0 shows up. If it does, type 'dhcpcd 
eth0'. Did you skip the step in the Install doc about setting up your 
NIC after you've installed everything?

Jacob Melgaard wrote:
But when the installation was done, and I did a reboot, the network card 
was not found. /sbin/ifconfig only shows lo, there’s no eth0 anymore. 
How is this possible? And how can I set up my NIC again, manually?

--
Andrew Gaffney
--
[EMAIL PROTECTED] mailing list