On Tue, 22 Jul 2003 04:43 am, Tom Wesley wrote: > Hi all, > > Has anyone been able to get the above to work without freezing the system, and > giving some meaningful results? > > So far I have found that the proper modprobe sequence is: > > modprobe i2c-dev > modprobe w83781d init=0 force_subclients=0,0x2c,0x4a,0x4b > modprobe i2c-amd756 > > And this at least doesn't lock the system solid, but it gives many alarms in > the sensors, and I am reasonly certain that they should not be alarming. > Does anyone else have the same board? > > -- > Tom Wesley >
I have this MB (or the MP2450, I can't find the manual at the moment so I am not sure). I'm fairly certain that my MB does not have the sensor hardware, as it was the low-end model in the range. Higher priced models included more devices on the MB (Ethernet, etc) and somewhere along the line the sensors get added. I know there are a few blank areas on my MB where this extra hardware would fit, if it was installed. -- Reverend Paul Colquhoun, ULC. http://andor.dropbear.id.au/~paulcol Asking for technical help in newsgroups? Read this first: http://www.tuxedo.org/~esr/faqs/smart-questions.html -- [EMAIL PROTECTED] mailing list
