Hi all folks,
This is my first time installing Gentoo.
Hardware Config.
RAID-0 (Z-Cyber ATA133 RAID)
Drive-A: Connected to 1st slot of RAID controller
Drive-B: Connected to 2nd slot of RAID controller
Motherboard
Primary IDE: Mobile hard-drive
(no drive installed for this test)
Secondary IDE: CDRom - AS Master
CDWriter - As Slave
2 network cards (brand unknown)
I did following steps;
1)Booting up the PC with CD#1
2)At prompt
# gentoo md
cdimage root# fdisk -l
Disk /dev/ide/host0/bus1/target0/lun0/disc: 40.0 GB
16 heads, 63 sectors/track, 77557 cylinders
Units = cylinders of 1008 = 512 = 516096 bytes
Devices /dev/ide/host0/bus1/target0/lun0/part1
Boot #
Start 1
End 77557
Block 39000696+
Id 83
System Linux
Disk /dev/ide/host0/bus0/target0/lun0/disc: 40.0 GB
255 heads, 63 sectors/track, 4866 cylinders
Units = cylinders of 16065 = 512 = 8225280 bytes
Devices /dev/ide/host0/bus0/target0/lun0/part1
Boot #
Start 1
End 9732
Block 78172258+
Id c
System Win95 FAT32 (LBA)
Why it is not a single hard drive, instead 2 drives being seen. One
drive is of Linux system and another Win95 FAT32 (LBA) system.
Kindly advise before I proceed further.
Thanks in advance.
B.R.
Stephen Liu
To Get Your Own iCareHK.com Email Address? Go To www.iCareHK.com.
--
[EMAIL PROTECTED] mailing list
