Just installed gentoo stage3 on an IBM Netfinity 4000R and I'm getting the following
kernel panic when I try to boot. This is my first attempt at installing gentoo. What
have I done wrong?
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1 p2 p3
---- Detected aic7xxx hardware
---- Scanning for aic7xxx_old...PCI: Enabling device 02:0f.0 (0116 ->
0117)
(scsi1) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 2/15/0
(scsi1) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi1) Cables present (Int-50 NO, Int-68 YES, Ext-68 NO)
(scsi1) Downloading sequencer code... 436 instructions downloaded
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.4/5.2.0
<Adaptec AHA-294X Ultra SCSI host adapter>
scsi0: Spurious SCSI interrupt
scsi0: Spurious SCSI interrupt
scsi0: Spurious SCSI interrupt
scsi0:A:10:255 Attempt to issue message failed
Kernel panic: HOST_MSG_LOOP with invalid SCB 0
In interrupt handler - not syncing
Thanks, Philip
