On September 24, 2016 10:35:58 PM GMT+02:00, Christopher Robinson <[email protected]> wrote: >Rich, > >Again thanks for a specific reply, unlike Dale and Neil's.
No need to become personal here. >I was detailing the end result after compiling the minimal install CD. Please explain, how are you compiling a CD? >I will check the manual to see if it addresses this. I was hoping to >get >a quick answer from the list and not to cause a ruckus. The quick answer was already goven by Neil. In order to install Gentoo, follow the handbook. -- Joost >-------------------------------------------- >On Sat, 9/24/16, Rich Freeman <[email protected]> wrote: > > Subject: Re: [gentoo-user] New Install > To: [email protected] > Date: Saturday, September 24, 2016, 4:00 PM > > On Sat, Sep 24, 2016 at > 3:22 PM, Christopher Robinson > <[email protected]> > wrote: > > Thanks again for your response. > After compiling I get the prompt: live cd # ~ > > I do not know what command to use to boot > the install. I looked through the manual > > but I did not see an answer for this. The > directions seemed to apply to a very > > > different install scenario. > >https://wiki.gentoo.org/wiki/Handbook:AMD64/Installation/Bootloader#Rebooting_the_system > > That is the last step after > configuring the bootloader (if you don't > configure the bootloader first you won't be > able to boot the system). > Are you sure you > completed all the steps in the handbook? I'm not > sure what you were compiling as there are a few > places where this can > happen. > > -- > Rich > > -- Sent from my Android device with K-9 Mail. Please excuse my brevity.
