Alle 15:39, sabato 25 marzo 2006, JimD ha scritto:
> On Sat, 25 Mar 2006 11:32:26 +0000
>
> [EMAIL PROTECTED] wrote:
> > Hi all
> > I have the need to configure my USRobotics internal modem (pci card)
> > for faxing. Running "lspci" the modem is not seen.
> > Should I load any module or enable any kernel entry (during the
> > installation of Gentoo I used genkernel)?
> >
> > Where may I find documentation on this topic?
> >
> > Bye
> > emilio
>
> Can you list the full output of lspci -v? The output of lspci -v
> should show something about the modem. Using that information, a
> google search may show what is needed to get the modem to work.
Well, using lspci -v
02:07.0 Serial controller: 3Com Corp, Modem Division 56K FaxModem Model 5610
(rev 01) (prog-if 02 [16550])
Subsystem: 3Com Corp, Modem Division Unknown device 00d7
Flags: medium devsel, IRQ 16
I/O ports at dc00 [size=8]
Capabilities: [dc] Power Management version 2
then dmesg | grep tty
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
0000:02:07.0: ttyS1 at I/O 0xdc00 (irq = 16) is a 16550A
So I think modem is on /dev/ttyS1.
Question: why cannot I set up KPPP?
> Jim
Bye
emilio
--
[email protected] mailing list
