Matthew R. Lee wrote: > Dear All, > I'm running out of space on my laptop (Compaq Presario V5000) so I've > decided > to intall a bigger hard disk. Currently I have an 80GB SATA drive, I'm also > going to add more RAM (from 1GB to 2GB) as RAM is so cheap at the moment. > I've been through various howto's online, including the one in the > gentoo-wiki, but I'm not completely clear on a couple of things. I need this > to go quickly and smoothly, I'm about to move house and job and I don't have > too much time for messing around. > > My current partition table looks like this: > > Disk /dev/sda: 80.0 GB, 80026361856 bytes > 255 heads, 63 sectors/track, 9729 cylinders > Units = cylinders of 16065 * 512 = 8225280 bytes > > Device Boot Start End Blocks Id System > /dev/sda1 * 1 5 40131 83 Linux > /dev/sda2 6 68 506047+ 82 Linux swap / > Solaris > /dev/sda3 69 9729 77601982+ 83 Linux > > I intend to keep the same partition layout on the new disk, but with /sda3 > being a lot bigger. > > So here's how I think I'll do this, please feel free to correct me if I'm > wrong. > 1. place the new 160GB SATA drive in an external housing and create the > partitions using fdisk, make the file systems, etc. > > Question 1: Should I keep the swap partition the same size or increase it? > > 2. Copy all the partitions from the old disk to the new disk using cp > > Question 2: (This is the main one!) The MBR? As the new disk is a direct > replacement for the old one, with the same partitions etc, do I need to > change anything in my grub.conf? or should it just work without > modification? > > Here's my current grub.conf: > > default 0 > > timeout 30 > > splashimage=(hd0,0)/boot/grub/splash2.xpm.gz > > title=Gentoo 2.6.22-r2 > > root (hd0,0) > kernel /boot/kernel-2.6.22-r2-2 root=/dev/sda3 > video=vesafb:mtrr,ywrap,[EMAIL PROTECTED] > > title=Gentoo 2.6.18-r6 > > root (hd0,0) > kernel /boot/kernel-2.6.18-r6 root=/dev/sda3 > video=vesafb:mtrr,ywrap,[EMAIL PROTECTED] > > 3. Shutdown, replace the old drive with the new drive, reboot and cross my > fingers :-) Will it work? > > Any comments, as always, greatly appreciated > Matt >
cp- a should work fine. I have used that several times and no problems yet. You can add the -v if you like to see the files scrolling by. If you have the same partitions on the new drive as the old drive, your grub.conf and fstab should be fine. You will need to install grub on the new drive tho. I usually do that from the Gentoo CD myself. Hope it all goes well. Dale :-) :-) -- [EMAIL PROTECTED] mailing list
