Hi list,
I'm doing some work on improving restconfig.
When putting some resource via rest in geoserver, in case everything goes
ok, you will receive a response with a return code = 201 --> handlePut does
this: getResponse().setStatus( Status.SUCCESS_CREATED );
>From [1] I see that the response should contain some info about the newly
created resource.
This can be achieved by properly setting an Entity in the response, before
setting Status.SUCCESS_CREATED.
Actually, geoserver simply set CREATED in the response without any
additional info. Therefore, there isn't any information about the just added
layer.
Which type of information should we provide within the response?
Any feedback is welcome.
Regards,
Daniele
[1]: http://www.w3.org/Protocols/rfc2616/rfc2616-sec10.html
--
-------------------------------------------------------
Eng. Daniele Romagnoli
Software Engineer
GeoSolutions S.A.S.
Via Carignoni 51
55041 Camaiore (LU)
Italy
phone: +39 0584983027
fax: +39 0584983027
mob: +39 328 0559267
http://www.geo-solutions.it
-------------------------------------------------------
------------------------------------------------------------------------------
The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your
production scanning environment may not be a perfect world - but thanks to
Kodak, there's a perfect scanner to get the job done! With the NEW KODAK i700
Series Scanner you'll get full speed at 300 dpi even with all image
processing features enabled. http://p.sf.net/sfu/kodak-com
_______________________________________________
Geoserver-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/geoserver-devel
