Good day I love the new uniform transform tool in Gimp 2.10. I do aerial photo overlays and it makes the number of steps needed to bring a different aerial photo over the top of an existing one, much faster.
However there have been some challenges which may or may not be an incomplete implementation at this time or perhaps some bug in the software. More than once after completing the preview alignment I have forgotten to click the Transform button and gone on to another step and then discovered there is no way of getting back to transform. While you are in the transform preview you can undo specific steps, but as soon as you have gone out of the transform then there is no way of going back into the transform and retrieving it. Looking through the undo list none of those transform preview steps are in the undo list. As soon as you would accidentally go out of the transform tool it evidently just dumps all the individual steps. I think the transform preview steps need to be included in the undo list all the time, not just when you are actually setting up a transform, because it is so easy to accidentally click the wrong thing and hey, it's just dumped all the stuff you did and you have to start again. -- BWK (via www.gimpusers.com/forums) _______________________________________________ gimp-user-list mailing list List address: gimp-user-list@gnome.org List membership: https://mail.gnome.org/mailman/listinfo/gimp-user-list List archives: https://mail.gnome.org/archives/gimp-user-list