Hi Kevin,
There could be two known issues.
1. Check if last IP address of storage pool is free by pinging to it. If the IP
address is in use, please adjust storage pool to make sure the last IP address
is not in use.
2. As the installer tries to connect to first server using eth0, you can connect
all NICs of new server into the switch where first server is connected. After
installation, you can switch back NIC cabling as per your required setup.
Both issues were fixed in our upcoming 3.1 release and Platform 3.1Alpha0 is
available for testing. You can download it from http://dev.gluster.com/downloads/
Thanks,
Regards,
Bala
[email protected] wrote:
I've successfully installed the first node, configured the management
network interface, an ALB bond I want to use for the storage network,
and the storage pool addresses. When I boot the new node it seems to
work correctly but just sits in "finding first server" drawing "...."
forever. The first node is sitting in the "Add Server/Probing server
..." dialog box. I've tried rebooting the new node several times
without success.
When you add a new node is the management network interface used to
probe for new nodes, or if you've defined a separate storage network (as
I have) does it use that interface for the probes? Any ideas on how to
solve this would be appreciated. There's nothing in any logs, and
without shell access troubleshooting is extremely difficult.
Thanks,
Kevin
_______________________________________________
Gluster-users mailing list
[email protected]
http://gluster.org/cgi-bin/mailman/listinfo/gluster-users
_______________________________________________
Gluster-users mailing list
[email protected]
http://gluster.org/cgi-bin/mailman/listinfo/gluster-users
