Kevin - Could you send over a screenshot and create a tarball of /GLUSTER from the GlusterSP server? To login to the server -
#ssh gluster@<server> Password - 'glusteradmin' #sudo -s Thanks. -- Craig Carl Gluster, Inc. Cell - (408) 829-9953 (California, USA) Gtalk - [email protected] From: [email protected] To: "Craig Carl" <[email protected]> Cc: [email protected] Sent: Thursday, September 23, 2010 5:06:14 PM Subject: Re: [Gluster-users] Gluster Storage Platform 3.0.5 fails to detect new nodes On Wed, 22 Sep 2010, [email protected] wrote: > Thank you. The problem turned out to be a bad GigE card in the new node. The > information both you and Bala provided was extremely helpful in isolating and > resolving the cause. I'm going to replace the card today and I'm sure things > will start to work correctly. Replacing the card did not in and of itself solve the problem, none the less I was able to get the new node to install. Now that it is installed (everything seemed to work perfectly) I've rebooted the server (fixing the disk "boot" parameter on an intel based server issue) but the new node still isn't showing up as being active in the server manager. It has a place holder for the new node (named "gluster2") but it's status is red and it has no IP address, etc. I can ping the new server so it's up and running on the net, and I can login to it on the console and things appear to be setup and running correctly. Any tips on what to try next to figure out why the new node isn't being seen (in whole) by the server manager would be appreciated.
_______________________________________________ Gluster-users mailing list [email protected] http://gluster.org/cgi-bin/mailman/listinfo/gluster-users
