Hi,
with the "Coherence;" command, when two points are merged, that can create a zero-lenght line and the 2nd order meshing
fails.
We added a test that prints an error when zero-length lines are encountered.
Can you try the latest nightly build ?
Regards,
Dave
--
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
WWW: http://hpc.montefiore.ulg.ac.be/
Agenda: http://www.google.com/calendar/embed?src=david.colignon%40gmail.com
On 01/02/10 11:50, 정상엽 wrote:
Dear gmsh developer
When i meshing the geometry that is contained in this mail,
In GUI, it suddenly stop and distinguish,
And in Non-GUI mode, i wrote down as follows:
>> gmsh per_voron.geo -3 -algo del3d -order 2 -clscale 1.0 -o
per_voron.msh
then it stops at 2D meshing step.
When I check the geometry, there is no error or fault.
Can you tell me why I cannot meshing this geometry??
Regards,
Chung
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
