Hi Martin, thank you for your answer. How do I define such an anisotropic mesh size field? Do you have a short example, or is this described somewhere? I did not find it in the Reference manual.
Best regards, Matthias Von: Martin Vymazal [mailto:[email protected]] Gesendet: Donnerstag, 16. Februar 2012 12:17 An: [email protected] Betreff: Re: [Gmsh] anisostropic meshing / bamg algorithm Hello Matthias, you can use the bamg algorithm by calling 'gmsh -2 -algo bamg my_file.geo' from command line. For 3d anisotropic mesh, you do the same with '-3 -algo mmg3d'. You need to supply a mesh size field which will tell the anisotropic algorithm in which direction to refine the mesh. Best regards, Martin Vymazal On Thursday 16 February 2012 10:56:06 Zenker, Dr. Matthias wrote: Hi, does anyone have an answer to the question below? It was said that an anisotropic mesh can be achieved using the bamg algorithm. I have some questions: 1. My 3D geometry consists of several layers stacked in z direction. Some of these layers are rather thin. I would like to have a mesh which is finer in z direction than in x and y direction. Can this be achieved using the bamg algorithm? If so, how? 2. How can I access this algorithm from the GUI? I did not find it in Options – Mesh. 3. If not accessible from the GUI, how else can I use it? 4. Is there any documentation available concerning this topic? I did not find anything in the gmsh manual (which is from October 2010 btw). Thank you, Matthias ---------------------------------------------------------------- ERBE Elektromedizin GmbH Dr.rer.nat. Matthias Zenker Dipl. Phys. Grundlagenentwicklung / Fundamental Development Waldhoernlestrasse 17 72072 Tuebingen Germany Phone + 49 (0) 7071 755 - 226 Fax + 49 (0) 7071 755 - 5226 E-Mail: <mailto:[email protected]> URL: http://www.ERBE-med.com ---------------------------------------------------------------- _____________________________________________________________________ ERBE Elektromedizin GmbH Firmensitz: 72072 Tuebingen Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede Registergericht: Stuttgart HRB 380137 _____________________________________________________________________ ERBE Elektromedizin GmbH Firmensitz: 72072 Tuebingen Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede Registergericht: Stuttgart HRB 380137
_______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
