Greetings,
I think I figured it out; I looked at the actual file,and saw that the numbers
were all out of sequence. Most likely from when I edited it, but did not reload
the model. So I started from scratch, and it seemed to work this time around.
Thanks again, and best regards,
-DA
________________________________
From: Dragon Age <[email protected]>
To: "[email protected]" <[email protected]>
Sent: Tuesday, August 7, 2012 10:28 AM
Subject: GMSH to Elmer
Greetings,
I've just started using GMSH in conjunction with Elmer, and have encountered a
problem for which I cannot find a solution. Whenever I import my GMSH model
into Elmer, it ends up having only 1 surface, which is the entire model. So for
example, say I make a cube in GMSH. I then 3D mesh it, then define physical
groups by selecting each of the faces. I save as a MSH file with the default
options (no boxes checked). I load it up into Elmer, and it only has 1 surface,
which is the entire cube, irregardless of where I click.
What am I doing incorrect?
Thanks, and best regards,
-DA
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
