Thanks for the explanation. But then how can one perform a one layer
extrusion from a step file (contains a 2D geometry). ?
With the geo file, the surface is clearly defined (i.e. Plane Surface(1) =
{1}; ) and one could simply add :
Extrude {0, 0, 50} {
Surface{1};
Layers{1};
Recombine;
}
And then do 3D meshing. All could be done in command line. Except the step
of converting .step to .geo file.
Thanks again for your help,
Zong
On Fri, Aug 31, 2012 at 2:08 PM, David Colignon <[email protected]>wrote:
> Hi,
>
> http://www.geuz.org/pipermail/**gmsh/2010/005910.html<http://www.geuz.org/pipermail/gmsh/2010/005910.html>
>
> Regards,
>
> Dave
>
>
> --
> David Colignon, Ph.D.
> Collaborateur Logistique du F.R.S.-FNRS
> CÉCI - Consortium des Équipements de Calcul Intensif
> ACE - Applied & Computational Electromagnetics
> Sart-Tilman B28
> Université de Liège
> 4000 Liège - BELGIQUE
> Tél: +32 (0)4 366 37 32
> Fax: +32 (0)4 366 29 10
> WWW: http://www.ceci-hpc.be/
> Agenda: http://www.google.com/**calendar/embed?src=david.**
> colignon%40gmail.com<http://www.google.com/calendar/embed?src=david.colignon%40gmail.com>
>
>
>
> On 30/08/12 14:13, Zong wrote:
>
>> Hello all,
>>
>> I am trying to read a .step file into gmsh and save as a unrolled geo
>> file. Everything worked fine under GUI. When I tried to use command
>> line by "gmsh -0 xxxx.step" , it did prompt "STEP Loading done : 1486
>> Entities" and " Info : Done writing 'xxxx.geo_unrolled'" .
>> However, the file xxxx.geo_unrolled only contained one line: "cl1 =
>> 1e+22;" without any geometry entries.
>> Is it a bug or I missed something ?
>> The problem was found on both 2.6.1 mac and windows build.
>>
>> Zong
>>
>> ______________________________**_________________
>> gmsh mailing list
>> [email protected]
>> http://www.geuz.org/mailman/**listinfo/gmsh<http://www.geuz.org/mailman/listinfo/gmsh>
>>
>>
>
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
