Ah I see. I didn't know you could look at the code in a text editor to fix errors. Thank you!
-Alejandro On Fri, Nov 8, 2013 at 1:21 AM, Zenker, Dr. Matthias < [email protected]> wrote: > Hi, > > > > there were several problems in your geometry: > > > > · The surfaces were defined multiple times, and were overlapping. > You need to define the heater loop as hole of your square surface. > > · The characteristic length of 1 was very small, given the length > of 1000 of your square. That made gmsh crash for me. I changed it to 5, and > 50 for the outer surface points. > > · Minor: The lines of the heater loop are duplicated – the > coherence command takes care of that. > > > > I have attached a fixed geo file that works for me. > > > > HTH, > > > > Matthias > > > > *Von:* Alejandro Ceballos [mailto:[email protected]] > *Gesendet:* Donnerstag, 7. November 2013 19:09 > *An:* [email protected] > *Betre**ff:* [Gmsh] Unable to mesh this complex geometry. Gmsh crashes > > > > Hello everyone, I started using gmsh this week to create a mesh of the > geometry attached below. I cannot get this to mesh, as the program crashes > upon attempting to do so. What is wrong with my geometry that is crashing > gmsh? > > Thank you, > > -Alejandro > > > _____________________________________________________________________ > ERBE Elektromedizin GmbH > Firmensitz: 72072 Tuebingen > Geschaeftsfuehrer: Christian O. Erbe, Reiner Thede > Registergericht: Stuttgart HRB 380137 > >
_______________________________________________ gmsh mailing list [email protected] http://www.geuz.org/mailman/listinfo/gmsh
