Hi,
Can you try with:
Geometry.ScalingFactor
Global geometry scaling factor
Default value: 1
Saved in: General.OptionsFileName
Regards,
Dave
--
David Colignon, Ph.D.
1er logisticien de recherche
Université de Liège
ACE - Applied & Computational Electromagnetics
Sart-Tilman B28
10, Grande Traverse
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
http://www.ulg.ac.be/nic4
On 04/04/16 21:03, [email protected] wrote:
Hello,
I was wondering if it's possible to change the scaling of every point defined
in my code with a factor 100 immediately in the .geo file?
I am actually looking for an iterative methode as the scaling command of the
Gmsh interface requires (if i'm right) to select each point one by one. The
underlying problem of my situation is that i've already created one thousand of
points...
Kind regards.
Nicolas Bouvier.
_______________________________________________
gmsh mailing list
[email protected]
http://onelab.info/mailman/listinfo/gmsh
_______________________________________________
gmsh mailing list
[email protected]
http://onelab.info/mailman/listinfo/gmsh
