Good morning sir,
I saw your post on Gmsh regarding the generation of a 3D mesh between
two irregular surfaces (from 2015)
--> see http://onelab.info/pipermail/gmsh/2015/009979.html
Did you finaly fixed your issue?
I have the same challenge - try to convert a geological 3D model
computed with GoCAD (geological formations are modelled as 3D planes,
one for the top of the formation, the other for the basement) to a 3D
volume.
I downloaded Gmsh and I start to read the doc - but I did not found the
way for solving the mesh generation.
Any input from your side would be very kind.
A precision: I am working in a folded context, that means that the
basement of a formation is not always below the top of the formation -
especially for reverse folds... Do you think that it could disturb the
mesh generation process?
Many thanks
Best regard
Arnauld Malard
--
AM_bot_email <http://www.casimages.com/i/160502083100238860.jpg.html>
_______________________________________________
gmsh mailing list
[email protected]
http://onelab.info/mailman/listinfo/gmsh
