Thank you! A.
-----Messaggio originale----- Da: Christophe Geuzaine [mailto:[email protected]] Inviato: mercoledì 6 settembre 2017 10:28 A: Alessandro Vicini Cc: [email protected] Oggetto: Re: [Gmsh] Control points not cocircular Hi Alessandro, I fixed the bug. The spurious errors were issued because we tried to recompute curve parameters every time we transformed (rotated/translated) the control points; the parameter recomputation is now done once the whole list of points has been transformed. Christophe > On 6 Sep 2017, at 09:16, Alessandro Vicini <[email protected]> > wrote: > > > Any help regarding the problem described below...? Thanks... > > -----Messaggio originale----- > Da: gmsh [mailto:[email protected]] Per conto di > Alessandro Vicini > Inviato: lunedì 4 settembre 2017 15:48 > A: [email protected] > Oggetto: [Gmsh] Control points not cocircular > > > The attached geo file gives a number of "control points of circle [...] are > not cocircular" errors. > Anyway, the geo file is read and it works fine. The control points actually > are cocircular, except perhaps for a small numerical tolerance. > So my question is: how is it possible to avoid these being printed out as > "errors"? Thank you. > > Alessandro > > _______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh -- Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine Free software: http://gmsh.info | http://getdp.info | http://onelab.info _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
