> On 25 Sep 2017, at 16:55, Clément Blanchard > <[email protected]> wrote: > > Dear Gmsh team, > > I have to design a cylinder with a patch on its side and a stripe tied to the > cylinder by a common edge with the patch, see the attached .geo file. To do > that, I tried to use Embed lines, Compound Surface and Boolean Difference but > its seems that those tools do not work together very well.
Indeed, this is not supported. Compounds are on the way out, and will be replaced in a future version with a more robust implementation. > These 5 errors occurred: > > Error : Could not open file 'debugp.pos' > Error : Could not open file 'debugr.pos' > Error : Unable to recover the edge 125 (1/5) on GEdge 11 (on GFace 11) > Error : Could not open file 'wrongmesh.pos' > Error : Could not open file 'wrongparam.pos' > > Is there a way to deal with this? > > Thank you for your time. > > Best regards, > Clément Blanchard > <mnwe.geo> > > > > > Clément Blanchard > PhD Student > GeM - UMR CNRS 6183 - research institute in civil enGineering and Mechanics > UFR des Sciences et Techniques de Nantes > Bâtiment 3, recherche physique > 2, chemin de la Houssinière - BP 92208 > 44322 Nantes CEDEX 3 > Bureau : 050 > Téléphone : +33 2 51 12 55 34 (int. 45 55 34) > > > MécaNantes > Le réseau des étudiants et diplômés en mécanique de l’université de Nantes > > > > Pensez au futur, n'imprimez ce message que si c'est vraiment nécessaire. > > _______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh -- Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine Free software: http://gmsh.info | http://getdp.info | http://onelab.info _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
