Dear all,
In Gmsh, I have a test.geo file. The question is: if I run gmsh -3 test.geo in the command line, I get the below error. Error : Surface mesh is wrong, cannot do the 3D mesh Info : Done meshing 3D (0.002836 s) Info : 927 vertices 2064 elements Error : ------------------------------ Error : Mesh generation error summary Error : 0 warnings Error : 2 errors Error : Check the full log for details Error : ------------------------------ if I partition the test.geo in Gmsh GUI, sometimes I get the same error as above. But if I reload test.geo and then 3D it many times, I am sure I can get the right 3-D partition. The test.geo file can be obtained from test.geo file So how does this happen?
_______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
