Hello,
Is there a way to get the mesh volume calculated by gmsh?
My simulator is calculating a volume of 1.09e-15 for the attached
structure, but it should be 1e-15.
Before I added these flags
Mesh.OptimizeNetgen=1;
Mesh.OptimizeThreshold=1;
I was getting 1.17e-15.
I am summing the volume for each tetrahedron sub volume from the edge
center, to the element center, to the centers of each triangle face of
the edge.
If my calculation is correct, are there flags I can use to improve the
situation?
I am running version 3.06.
gmsh -3 3dblock.geo
Regards,
Juan
Mesh.OptimizeNetgen=1;
Mesh.OptimizeThreshold=1;
Mesh.ScalingFactor=1e-5;
w = 1;
cl = 5e-2;
xl = 0.0;
xh = w;
yl = 0.0;
yh = w;
zl = 0.0;
zh = w;
Point(1) = {xl, yl, zl, cl};
Point(2) = {xh, yl, zl, cl};
Point(3) = {xh, yh, zl, cl};
Point(4) = {xl, yh, zl, cl};
Point(5) = {xl, yl, zh, cl};
Point(6) = {xh, yl, zh, cl};
Point(7) = {xh, yh, zh, cl};
Point(8) = {xl, yh, zh, cl};
Line(1) = {3,7};
Line(2) = {6,2};
Line(3) = {6,7};
Line(4) = {3,2};
Line(5) = {8,7};
Line(6) = {8,4};
Line(7) = {3,4};
Line(8) = {8,5};
Line(9) = {5,1};
Line(10) = {4,1};
Line(11) = {1,2};
Line(12) = {5,6};
Line Loop(13) = {1,-3,2,-4};
Plane Surface(14) = {13};
Line Loop(15) = {5,-3,-12,-8};
Plane Surface(16) = {15};
Line Loop(17) = {12,2,-11,-9};
Plane Surface(18) = {17};
Line Loop(19) = {11,-4,7,10};
Plane Surface(20) = {19};
Line Loop(21) = {7,-6,5,-1};
Plane Surface(22) = {21};
Line Loop(23) = {10,-9,-8,6};
Plane Surface(24) = {23};
Surface Loop(25) = {22,20,18,16,14,24};
Volume(26) = {25};
Physical Surface("top") = {20};
Physical Surface("bot") = {16};
Physical Volume("Bulk") = {26};
_______________________________________________
gmsh mailing list
[email protected]
http://onelab.info/mailman/listinfo/gmsh
