> On 2 Aug 2018, at 15:59, Anja Miehe <[email protected]> wrote: > > Hello everyone, > I have a question concerning the generation of matching meshes. I need the > stl files of a cylinder with top, bottom and circumference separately named > so I use 3 different .geo files as attached (generateSTL is the batch sh file > to run all the commands) > What I find strange is, that the “Transfinite Line” command and the “Layers” > command in Extrude handle the number parameter differently. Only Layers = n > and Transfinite Line = n+1 result in matching meshes. > Is there any reason for it?
Purely historical : one sets the number of elements (layers) ; the other the number of nodes. Christophe > Thanks in advance > > Kind Regards / Mit freundlichen Grüßen > Dr.-Ing. Anja Miehe > Digitalization Research Scientist > > Phone: +49 621 60-90856, Mobile: +49 1525 4914637, Email: [email protected] > Postal Address: BASF SE, ROM/CC - L540-117, Carl-Bosch-Strasse 38, 67056 > Ludwigshafen am Rhein, Germany > <image001.png> > BASF SE, Registered Office: 67056 Ludwigshafen, Germany > Registration Court: Amtsgericht Ludwigshafen, Registration No.: HRB 6000 > Chairman of the Supervisory Board: Juergen Hambrecht > Board of Executive Directors: > Martin Brudermueller, Chairman; Hans-Ulrich Engel, Vice Chairman; > Saori Dubourg, Sanjeev Gandhi, Michael Heinz, Markus Kamieth, Wayne T. Smith > > > > > <generateSTL><inlet.geo><outlet.geo><wall.geo>_______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh — Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine Free software: http://gmsh.info | http://getdp.info | http://onelab.info _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
