Dear all, I am trying to define a small circular area on the outer surface of a truncated cone, see file attached.
After defining some points for the circle on the outer surface, and
using Ellipses and the feature "Points{...} In Surface{...}", the 3d
mesh does not take into account the circle; only the points are
correctly on the mesh.
It seems that the way I have built the circle is not correct: the circle
does not follow the curvature of the cylinder.
How can I construct the circle so that it fits with the truncated cone
and its volume mesh?
Thank you very much ahead for your help.
Best regards,
--
Najib Alia
MIMESIS PhD Student
-----------------------------------------------------------------
Research group "Numerical Mathematics and Scientific Computing"
Weierstrass Institute for Applied Analysis and Stochastics (WIAS)
Mohrenstr. 39, 10117 Berlin, Germany
-----------------------------------------------------------------
Contact in Finland (until July 2018)
Office address: SSAB, 133E/Rautaruukintie 155, 92101 Raahe
Office tel. +358 503143470
-----------------------------------------------------------------
Tel. +49 151 412 04833
[email protected]
circle_on_cylinder.geo
Description: application/vnd.dynageo
_______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
