> On 27 Nov 2018, at 13:26, Alessandro Vicini <[email protected]> > wrote: > > Ok, thank you, in the meantime I had found that out. From the manual I was > supposing that should work also with the built-in geometry Kernel…
Indeed; it's just a particular case that the built-in kernel does not handle... > > A. > > > Da: Christophe Geuzaine [mailto:[email protected]] > Inviato: martedì 27 novembre 2018 13:25 > A: Alessandro Vicini > Cc: [email protected] > Oggetto: Re: [Gmsh] Problem with extrusion > > > > > On 27 Nov 2018, at 11:17, Alessandro Vicini <[email protected]> > wrote: > > > Considering the attached geo file, why there is no surface generated by the > extrusion? Thank you. > > The built-in CAD engine is quite limited for the extrusion of curves: it will > not create surfaces if the origin and the destination curve are the only ones > bounding the resulting surface. > > You can use SetFactory("OpenCASCADE"); for such geometries: > > <image001.png> > > > > > Regards, > > Alessandro > > <extrude.geo>_______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh > > — > Prof. Christophe Geuzaine > University of Liege, Electrical Engineering and Computer Science > http://www.montefiore.ulg.ac.be/~geuzaine > > Free software: http://gmsh.info | http://getdp.info | http://onelab.info > — Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine Free software: http://gmsh.info | http://getdp.info | http://onelab.info _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
