mike ledoux wrote: > > AIC7xxx is the one you need--the chip on the HBA is an AIC7xxx. > This applies to just about every recent Adaptec card: if it can handle > Fast/Wide or better, it probably uses the AIC7xxx driver.
That was easy... The SCSI card works. The tape drive attached to it, on the other hand, is being a bit more difficult. It shows up in /proc/scsi/scsi as: webby:/home/kenny# cat /proc/scsi/scsi Attached devices: Host: scsi0 Channel: 00 Id: 06 Lun: 00 Vendor: ARCHIVE Model: Python 00095-001 Rev: 5.45 Type: Sequential-Access ANSI SCSI revision: 02 So it's there, and the system sees it. However, I can't access /dev/st0, or any variation thereof. C-Ya, Kenny -- --------------------------------------------------- Kenneth E. Lussier Geek by nature, Linux by choice PGP KeyID C0D2BA57 Public key http://pgp.mit.edu:11371/pks/lookup?op=get&search=0xC0D2BA57 ***************************************************************** To unsubscribe from this list, send mail to [EMAIL PROTECTED] with the text 'unsubscribe gnhlug' in the message body. *****************************************************************