Hi, all, I have googled this error message, but literally nothing is found.
I am trying to install NexentaCP 1.0RC5 to a Dell Precision 650 Workstation. I selected auto-partition option, but I encountered the following error: "Cannot auto-partition /dev/rdsk/c0t0d0p0 disk with error: Mode sense page(3) reports nsect value as 936, adjusting it to 747" The installation can proceed if I clicked OK to dismiss this message. But after the installation and reboot the machine, the OS cannot be loaded due to "Bad PBR sig". If I looked at the log, I can see this line after "*GRUB installed on" fdisk: Cannot stat device /dev/rdsk/p0 What could be the problem and potential remedy? Any suggestion is welcome. Cheers, Anthony -- /*--*/ Don't EVER make the mistake that you can design something better than what you get from ruthless massively parallel trial-and-error with a feedback cycle. That's giving your intelligence _much_ too much credit. - Linus Torvalds _______________________________________________ gnusol-users mailing list [email protected] http://lists.sonic.net/mailman/listinfo/gnusol-users
