Okay that worked (if I do it twice then restart grass, go figure.)
Anyway. It keeps on happening. I am trying to snap the nodes along
my coastline. I also have to draw three lines to enclose my water.
For trying to snap the nodes, I have been using the MOVE VERTEX to
attempt this (as per the book). I am having a hard time getting it to
snap. I try increasing magnification, and that is when the G_malloc
likes to strike. So I want to do this in as few a steps as possible,
and then get out.
Any thoughts.
Kurt
On Nov 20, 2008, at 11:21 PM, Hamish wrote:
Kurt:
I am running into a problem I've never seen before. I
was trying to digitize a vector file. I had imported it
from a dxf file and was trying to close up some vectors
points. Suddenly v.digit closed, and when I tried to reopen
I got:
v.digit(4314,0xa0371fa0) malloc: *** mmap(size=1207963648)
failed (error code=12)
*** error: can't allocate region
*** set a breakpoint in malloc_error_break to debug
G_malloc: out of memory
whenever v.digit crashes try "v.build mapname" to recover.
Hamish
_______________________________________________
grass-user mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/grass-user
