Hello I've just tried with the solution of this thread https://www.mail-archive.com/[email protected]/msg40640.html so > v.in.lines -z --overwrite input=fosso.dat output=fosso_linea / > separator=comma > g.region vector=fosso_linea res=0.2 > v.split input=fosso_linea output=fosso_linea_split length=0.2 > v.to.points -i input=fosso_linea_split output=fosso_punti > v.to.rast -d input=fosso_punti type=point output=fosso_dem use=z but the result is > Command ended with non-zero return code -11 (0 sec)
I believe there was something wrong in v.in.lines or in my ASCII file: the vector line hasn't attribute Il giorno lun, 24/07/2023 alle 16.44 +0200, bonushenricus ha scritto: > Hello > I would like to use the procedure described in "Open Source GIS: A > GRASS GIS Approach" second edition page 191 "7.3.5 Surfaces with > faults". > I have a survey of points. Some points are two ditches. I have run a > v.surf.rst with the survey points without the ditch. > Attached is the ascii file of the ditch points (EPSG:32632) > I have therefore operated as follows: > > v.in.lines -z --overwrite input=fosso.dat output=fosso_linea / > > separator=comma > > g.region vector=fosso_linea res=0.2 > > v.to.rast -d --overwrite input=fosso_linea type=line output=fosso / > > use=z > > v.surf.rst --overwrite segmax=60 npmin=100 dmin=1 dmax=6 / > > input=fosso_linea elevation=fosso_dem mask=fosso > the result is with no_data > > Some suggestions? > -- _______________________________________________ grass-user mailing list [email protected] https://lists.osgeo.org/mailman/listinfo/grass-user
