Carlos,
Thank you for your help. It sounds like I might as well write a simple
script because anytime I would want to do this, I would need to create a
new location. Either I would end up with a bunch of lat-lon locations,
or I would need to delete the one I just created afterwards. So, I might
as well write a simple script to handle this process and do the clean-up.
Regards,
Tom
Carlos "Guâno" Grohmann wrote:
You can create a new location in the import step, so you don't have to
exit from your lambert location.
c
On 7/20/07, Thomas Adams <[EMAIL PROTECTED]> wrote:
List,
What is the most efficient way to import a lat-lon shapefile into, say,
a Lambert Conic Conformal location? Up to this point if I wanted to do
this, I would exit GRASS (6.2.1) from my Lambert Conic Conformal
location. Then, start-up GRASS in a lat-lon location, import the
shapefile, then, exit GRASS, and re-start GRASS into my LCC location,
where I would reproject the map from the lat-lon location into my LCC
location. OBVIOUSLY, this works (and I could write a simple script to
automate this), but it seems there ought to be a way to do this all
within my original LCC location. So, is there some way to do this — it's
not very obvious to me.
Regards,
Tom
--
Thomas E Adams
National Weather Service
Ohio River Forecast Center
1901 South State Route 134
Wilmington, OH 45177
EMAIL: [EMAIL PROTECTED]
VOICE: 937-383-0528
FAX: 937-383-0033
_______________________________________________
grassuser mailing list
[email protected]
http://grass.itc.it/mailman/listinfo/grassuser
--
Thomas E Adams
National Weather Service
Ohio River Forecast Center
1901 South State Route 134
Wilmington, OH 45177
EMAIL: [EMAIL PROTECTED]
VOICE: 937-383-0528
FAX: 937-383-0033
_______________________________________________
grassuser mailing list
[email protected]
http://grass.itc.it/mailman/listinfo/grassuser
